Nut Commodity Code Substitution Rule - Intergraph Smart 3D - Reference Data - Hexagon PPM

Intergraph Smart 3D Piping Reference Data

Intergraph Smart 3D
Search by Category
Reference Data
Smart 3D Version

The Nut Commodity Code Substitution Rule node (the NutCommodityCodeSubstRule sheet in the Connection Parts Commodity Code Substitution workbook) is an optional rule that you can use to define a nut's commodity code using the dimensional characteristics of the nut. This optional rule applies to all nuts.

This rule is used when the material control system requires the nut commodity code to serve as a part number that reflects the bolt diameter. The nut's commodity code used in the Piping Specification does not include the bolt diameter because those values are not known until the bolted joint is placed in the 3D model. This rule updates the commodity code of the bolt set in the model to reflect the bolt length and the bolt diameter.

Material Control System / Nut Commodity Code (Required)

Enter the commodity code to use for the material control system. This commodity code is not used to query the piping commodity material data for the bolt part.

Bolt Diameter (Required)

Specify the diameter of the bolt in in or mm.

Contractor Commodity Code (Required)

Enter the commodity code for the nut as defined in the Nut Selection Filter.

Weight (Optional)

Specify the weight of the nut.

See Also

Bolt Commodity Code Substitution Rule
Gasket Commodity Code Substitution Rule
Washer Commodity Code Substitution Rule