Mechanical End Data - Intergraph Smart 3D - Reference Data - Hexagon PPM

Intergraph Smart 3D Piping Reference Data

Language
English
Product
Intergraph Smart 3D
Subproduct
Piping
Search by Category
Reference Data
Smart 3D Version
13

The Mechanical End Data node (the PipingGenericDataMechanical sheet in the Piping Catalog.xls workbook) defines generic mechanical end data. The generic data that is required for mechanical ends is based on the specific end preparation. For example, the tangent length is required for extended tangent butt weld (ETBW) types of mechanical fittings. Likewise, the outside diameter and the thickness are required at male Tri-Clamp ends.

Body Outside Diameter (Conditionally Required)

Enter the fitting body outside diameter at the mechanical end. You can specify the body outside diameter in the piping commodity part data (or piping specialty part data or instrument part data) for certain fittings rather than specifying the value here. If you do not enter a value here or in the piping commodity part data (or piping specialty part data or instrument part data), the outside diameter must be available in the plain piping generic data for the same value of the end standard property. Include the units of measure, such as mm or in, when specifying this value.

End Practice (Required)

Select the end practice for the mechanical end.

End Preparation (Required)

Select the end preparation for the mechanical end.

End Standard (Required)

Select the end standard for the mechanical end.

Groove Depth (Optional)

Enter the groove depth. Include the units of measure, such as mm or in, when specifying this value.

Groove Width (Optional)

Enter the groove width. Include the units of measure, such as mm or in, when specifying this value.

Groove Setback (Optional)

Enter the groove setback. Include the units of measure, such as mm or in, when specifying this value.

Nominal Piping Diameter (Required)

Type the nominal piping diameter for the mechanical end.

Nominal Diameter Units (Required)

Specify the units for the nominal piping diameter. For example, mm or in. This unit of measure must be consistent with the port's unit of measure in the piping commodity part data for the piping commodity that references this reference data.

Pressure Rating (Conditionally Required)

Select the pressure rating for the mechanical end.

Rating Practice (Conditionally Required)

Select the pressure rating practice for the mechanical end.

Termination Class (Required)

Select the Mechanical termination option.

Termination Sub Class (Required)

Select the termination sub class for the mechanical end.

SP3D PIPING Mechanical End Data CONCEPT

A

Groove Setback

B

Tangent Length

C

Groove Depth

D

Groove Width