Click Circle on the toolbar to display the Draw Circle properties in the State Manager.
Parameters
Center point X,Y
Specifies the X,Y coordinates of the center point of the circle.
Circle radius
Specifies the radius of the circle.
Add relation
Contains commands for adding relations to other geometry elements, such as lines and circles. You can add up to two relations. If existing properties contradict a relation, the software displays a message and does not add the relation. The following relations are available.
Tangential with line
Tangential with circle
Point
Existing relations
Displays the relations selected from Add relation. Click a relation to display properties you can modify, or remove the relation. The Tangential with line relation is selected in the example below.
Tool
Specifies how the software interprets the elements when you create cutting paths in the Nesting work area. The following modes are available:
-
Basic Cutting
-
Marking Line
-
Marking Point
-
Painting
-
Ridge
-
Info
-
Marking Text
-
Drilling
Specifies the cutting speed to control the cutting quality.
Specifies whether the software uses the inner profile. The following options are available:
-
Normal
-
NotMirrored
-
Mirrored