-
Click SRD > XS10 Component Manager > XS1010 Commodity/Ident Management.
-
Select Commodity Group/Part/Commodity Code from the list.
-
Navigate down through the hierarchy, and double-click a commodity code to open the grid.
To navigate to the Company Idents page, right click Commodity Code and select Company Idents.
-
Click the Idents tab at the bottom of the grid.
-
In the Preparation section, click Assign code with object.
-
Type an object code, or browse to select an object code.
-
Click Save on the toolbar.
-
Click Assign code with geometric, and then click ellipses .
-
Click Matched Geometrics.
Matched Geometrics displays only those geometrics that match with the selected Objectparameter.
-
Select Geometric from the list and then click OK.
-
To save the selected geometric as an Ident Geometric, click Ident Geometric and then click Save .
If Matched Geometrics is not selected in Step 9, then all the geometrics appear. If you select a geometric that does not match with the Objectparameter, then you cannot make that geometric as an Ident Geometric.
-
In the New idents section, click Show new idents.
-
Do one of the following:
-
Filter the view as needed (for example, filter the nominal piping size To value to specify a range), and then click Build selected idents.
-
Click Build all idents.
-