-
Select Piping Tab > Insert Pipe Component Command to display the Insert Pipe Component Controls.
-
Select the pipe end at which to place the elbow.
-
Select Specification from Placement Type and 90 Degree Direction Change from Short Code.
The elbow appears at the pipe end.
-
Change the elbow orientation, if needed, using Rotation Angle.
-
Complete the placement:
-
Select Finish or press CTRL + ENTER to save your changes and exit the command.
-
Select Finish and Modify or press CTRL + SHIFT + ENTER to save your changes, and then start the modification of that object.
-
Select Finish and Repeat or press SHIFT + ENTER to save your changes, and then restart the command using the same options.
-