-
Select Structural Tab > Bracing Members Command
to display the Place Bracing Members Controls.
-
Define the Parent System for the braces.
-
In the Type category box, select the Brace type.
-
In the Type box, select Horizontal Brace.
-
Set the Cross Section, Material, Cardinal Point, and Angle options as required.
-
In the Bracing Type box, select Cross.
-
Select the first member to support the cross bracing. This member is one of the "side" members to which the bracing connects.
-
Select the second member to support the cross bracing. This member is the other "side" member to which the bracing connects.
-
Optionally, select one or two members to define the extent of the cross bracing. If you do not select these members, the software uses the end locations of the two selected members as the end locations of the cross bracing.
-
Complete the placement:
-
Select Finish
or press CTRL + ENTER to save your changes and exit the command.
-
Select Finish and Modify
or press CTRL + SHIFT + ENTER to save your changes, and then start the modification
of that object.
-
Select Finish and Repeat
or press SHIFT + ENTER to save your changes, and then restart the command using the
same options.
-