The Model Data Transform command moves and/or rotates a large portion of the design objects in a model from one location in the model to another. The software disconnects the selected objects from the surrounding objects before transforming them. This operation does not transform read-only objects or volumes. However, there is an option to allow the transformation of objects that are not in Working status.
-
When you attempt to use this command, the software performs two verification checks:
-
A permission group named MDRMDT PG exists in the Project Management hierarchy.
-
Your level of access to MDRMDT PG is set to Full Control.
-
-
If either of the conditions listed below exists, the command is not available. In these instances, you must contact your project administrator to gain access to the command.
-
Your level of access to MDRMDT PG is set to Read access or Write access.
-
-
The MDRMDT PG permission group does not exist.
You cannot undo an model data transform (MDT) operation. As such, best practice is to create a model backup before starting a model data transform operation.
New Operation
Creates a new model data transform operation. This command opens the Source Object Selection - MDT page, where you define operation parameters.
Delete Operation
Deletes a selected model data transform operation from the list. You cannot undo this action.
Restart Operation
Resumes an existing operation that is incomplete.
Last Refreshed < date/time>
Refreshes the operations grid. The date and time of the last refresh displays.
Operations Grid
The grid shows the status of all model data transform operations.
Operation Name
Displays the operation name. The default name is Transform_Operation_[Date]_[Time].
Created By
Displays the person who created the model data transform operation.
Created Date
Displays the date and time the operation was created.
Phase
Displays the operation phase.
Status
Displays the status of the operation.
Complete
The operation has finished successfully.
Incomplete
The operation was interrupted and did not finish. Use the Restart Operation command to finish an incomplete operation.
Operation Details
The selected operation details display at the bottom of the dialog. You can show or hide the details by clicking the arrow. Details are organized into three categories: General, By Class, and Configuration.