Opens the Clipping Manager dialog allowing you to create, edit, and delete clipping records in CloudWorx.
Clipping Manager Dialog
The dialog box has two panes. The left pane lists the clipping groups. A clipping group is a list of clipping records that are applied together to the point clouds. You can create, delete, or activate a group. At any time, there is one group activated. When activated, the clipping records display in the right pane. In the right pane, you can enable or disable a clipping record. You can invert a section view clipping or a fence clipping. When you click on the name of a clipping group or clipping record twice, the software allows you to rename it.
All clipping records are created with following commands:
Clipping Groups
Provides a list of clipping groups. You can select a clipping group, and then activate it using Activate Group. A clipping group is a list of clipping records that are applied together to the point clouds. You can create, delete, or activate a group. At any time there is one group activated. When activated, the clipping records display in the right pane.
Clippings
Provides a list of clipping records in the active clipping group. All the clipping records are applied to the point clouds.
Delete Clipping
Deletes the selected clipping record
Clear Clippings
Deletes all clipping records in the active clipping group.
Enable All
Enables all clipping records in the active clipping group.
Disable All
Disables all clipping records in the active clipping group.
Create Group
Creates a new clipping group. You can click the name twice to rename a group. By creating and activating a new clipping group, the last clipping group is protected. This is because the active clipping group can be cleared with a reset clipping command.
Delete Group
Deletes selected clipping group. You cannot delete the active clipping group.
Activate Group
Turns on the selected clipping group. Clipping records are updated.
Modify Limit Box Parameters
-
Select the Limit Box and right-click to select Modify.
The Limit Box Parameters dialog appears for you to edit.
-
You can directly change the values (Corner or Size components) and click another edit box to see the effect. You can use the up/down keys near each edit box. Note that the keys have different effects. Up/down key for a corner component moves along its axis direction. Up/down key for a size component enlarges or shrinks along each axis in both directions. The < and > buttons shrinks or enlarges the box in all directions.
The valid range of values is between 0.001 and 1000000.
-
After making the needed changes, click Apply to save the new changes to the points.
Apply is enabled only when there is a change in the limit box parameters.
-
Click Close to undo the changes. You are prompted for confirmation.
-
Click Yes to undo the change and restore the previous values.
-
Click No to stay on this dialog.
-
Delete Limit Box Parameters
-
Select the Limit Box and right-click to select Delete.
If a change in clipping exposes new area that is previously clipped out, you are prompted to regenerate the point clouds. Such change include clearing one or more clipping, moving slice forward or backward, inverting a clipping or changing a limit box. A message is displayed with Don't tell again (for the session).
You can also switch the clipping scheme using the menu CloudWorx > Clip Point Cloud > Toggle Single LimitBox/Slice.