Connect Pipes - CloudWorx for Intergraph Smart 3D - Help

CloudWorx for Intergraph Smart 3D Help

PPMProduct
CloudWorx for Intergraph Smart 3D
aSubProduct
Smart 3D
PPMCategory_custom
Help
Version_SThreeD_Custom
13

Connects the selected pipes (as construction lines) by minimized adjustment. Pipes usually are connected to the end points thus allowing you to do a pipe run.

To create a piping run

  1. Clear your selection.

  2. Hold down the CTRL key, and then pick pipe construction lines one by one.

    The connection is based on the sequence you select.

  3. Select CloudWorx > Fit Point Cloud > Connect Pipes.

    If the result is not what you expect, use Undo command to revert. The selection sequence might be wrong. Redo the selection and try again.