IJUAhsLug::TopShape
Specifies the shape that is used for the top of the lug.
1 - Curved 2 - Squared
3 - Rounded 4 - Chamfered
IJUAhsAngle1::Angle1
Specifies the angle between the start and the end points of the top curve. If the TopShape is not curved, then the software ignores this attribute. The Angle1 value must be positive and greater than 90 degrees and less than 270 degrees, else the software displays a warning message and resets the Angle1 value to 180 degrees.
IJUAhsWidth1::Width1
Specifies top width of the pipe lug. If Width1 is set to zero, then Width2 is used.
IJUAhsWidth2::Width2
Specifies the bottom width of the pipe lug. If the Width2 and Angle3 values are zero, then Width1 is used instead.
IJUAhsAngle2::Angle2
Specifies the angle of the left tapered portion. If you do not assign a positive value to Angle2 that is less than 30 degrees, the software displays an error message. If Angle2 is set to zero, then the left line is drawn as global vertical.
IJUAhsAngle3::Angle3
Specifies the angle of the right tapered portion. If you do not assign a positive value to Angle3 that is less than 30 degrees, the software displays an error message. Angle3 overrides Width2 to get the tapered bottom point.
IJUAhsThickness1::Thickness1
Specifies the thickness of the lug.
IJUAhsGap1::Gap1
Specifies the gap between the lug components of a double lug. If a value is not specified, then a single lug is drawn.
IJUAhsLug::StiffenerOffset
Specifies the distance a stiffener is offset between the two components of a double lug. StiffenerOffset is set from the center of pin port.
IJUAhsLug::StiffenerHeight
Specifies the height of the stiffener between the two double lug components.
IJUAhsLug::StiffenerLength
Specifies the length of the stiffener between the two double lug components.
IJUAhsOffset1::Offset1
Specifies the distance between the top of the lug and the top port. When TopShape is set to 1 - Curved, Offset1 is used as the eye radius.
IJUAhsLug::ChamfLength
Specifies the length of the chamfered edges. This attribute is valid only when TopShape is set to 4 - Chamfered.