Occurrence Attributes - Intergraph Smart 3D - Reference Data - Hexagon PPM

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
Hangers and Supports
Search by Category
Reference Data
Smart 3D Version
13.1

IJOAhsPipeOD::PipeOD

Specifies the actual outside diameter of the pipe or the insulation. The Assembly Information Rule (AIR) in Visual Basic or Custom Support Definition (CSD) in .NET passes the PipeOD value, but you can manually set the value as well. This attribute is used to position the strap vertically along with the StrapTopGap.

  • The software displays a warning if the PipeOD value is greater than StrapWidthInside value.

  • The software does not display a warning if the rectangular straps or the blocks interfere with the pipes.

  • The software does not get the PipeOD value from the supported pipe because the strap might be attached to a different piece of pipe within the assembly or might need to go outside the insulation.

IJUAhsBottomShapeType::ShapeType

Specifies the codelist value for the bottom shape.

1 - Round
2 - Rectangular

IJUAhsBottomShapeWidth::Width

Specifies the width of the bottom shape. This value must be greater than zero. If the bottom shape is 1, round, then the width is equal to the length.

Pipe Saddle - Occu Att - Bottom Shape Width

IJUAhsBottomShapeLength::Length

Specifies the length of the bottom shape. This value must be greater than zero. If the bottom shape is 1, round, then the width is equal to the length.

Pipe Saddle - Occur Att - Bottom Shape Lenght

IJUAhsBottomShapeHeight::Height

Specifies the height of the bottom shape calculated from the center of the pipe to the bottom end of the bottom shape. This value must be greater than half the outer diameter and thickness of the strap.

Pipe Saddle - Occur Att - Bottom Shape Height