Rectangular Wrap/Strap Properties - Intergraph Smart 3D - Reference Data - Hexagon PPM

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
Hangers and Supports
Search by Category
Reference Data
Smart 3D Version
13.1

These properties are optional. Enter the values for these properties to represent rectangular insulation wrap, solid blocks or any strap-shaped liners. There is no allowance for wings, one-sided straps or split strap shapes. The Thickness4 property determines if it is drawn as a block or as a strap.

IJUAhsWidth4::Width4 (Optional)

Specifies the outside width of a strap or a block. By default, the shape is drawn with the top as a half-circle with its diameter equal to Width4. This can be changed to a flat top using Width6 as a flat spot.

  • Strap

  • Block

IJUAhsHeight4::Height4 (Optional)

Specifies the outside height of the strap of block.

  • Strap

  • Block

IJUAhsThickness4::Thickness4 (Optional)

Specifies the thickness of the rectangular stock of wrap. If zero or greater than half of the width, then Thickness4 is ignored and the shape is drawn as a block rather than as a strap.

If Thickness4 is set to zero, then the block is drawn.

IJUAhsWidth5::Width5 (Optional)

Specifies the width of the rectangular stock used to make the wrap or block. If Width5 is set to zero, then the shape is not drawn.

IJUAhsWidth6::Width6 (Optional)

Adds a flat spot on top of the curved part. If set to zero, then the flat spot is not shown. For a block, if Width6 is greater than Width4, then the strap is drawn as a rectangular block with no curved top. For a strap, if Width6 is greater than Width4 - 2 * Thickness4, then the strap is drawn as a rectangular strap with no curved top.

If Width 6 is set to a positive value, a flat spot is added in the top curved section. This also reduces the radius and center points for the curves. It can be used to produce rectangular shapes rather than rounded tops.