IJUAhsStanShape::StanShape
Specifies the stanchion shape. Stanchion shape can be used as either top shape or bottom shape of the part. Stanchion shape can be used in IJUAhsBotShape::BotShape or IJUAhsTopShape::TopShape (at part class level). Allowed values are
1 - Cylinder
2 - Square/Rectangle
3 - Standard Steel
The above values are codelisted values from the hsDummyStanc sheet of the HS_S3Dcodelist.xls workbook.
Bottom Shape
Top Shape
IJUAhsStanHeight::StanHeight
Specifies the total height of the stanchion shape excluding the plate height. If StanHeight is not specified, then the shape is of variable length.
IJUAhsStanWidth::StanWidth
Specifies the width of the stanchion. StanWidth must be a positive value. If the stanchion shape is round, then StanWidth is used as the diameter. If the stanchion shape is set to standard steel, then StanWidth is not used.
IJUAhsStanDepth::StanDepth
Specifies the depth of the stanchion shape. If the stanchion shape is either round or standard steel, then StanDepth is not used.