IJUAhsTLCorner::TLCornerType
Specifies the corner type. Enter codelist value 7 for this corner type. Valid codes are listed in the HS_S3DParts_Codelist.xls workbook on the hsCornerShape sheet.
Codelist hsCornerShape 7- Rounded Corner (Convex)
IJUAhsTLCorner::TLCornerX
Specifies the horizontal offset of the round notch center point. The value must be negative. If a positive value is entered, the software will use the equivalent negative value.
If this value is set to zero, then the rounded corner will be tangent with each edge. The notch shape will be a quarter-circle arc.
X = 0, Zero Offset
If a negative value is set, then the software will move the center point away from the plate horizontally. This will reduce the sweep angle of the notch shape, so it will be less than a quarter-circle and the joint with one edge is no longer perpendicular.
X < 0, Negative Offset
IJUAhsTLCorner::TLCornerY
Specifies the vertical offset of the round notch center point. The value must be negative. If a positive value is entered, the software will use the equivalent negative value.
If this value is set to zero, then the rounded corner will be tangent with each edge. The notch shape will be a quarter-circle arc.
Y = 0, Zero Offset
If a negative value is set, then the software will move the center point away from the plate vertically. This will reduce the sweep angle of the notch shape, so it will be less than a quarter-circle and the joint with one edge is no longer perpendicular.
Y < 0, Negative Offset
IJUAhsTLCorner::TLCornerRadius
Specifies the radius of the round notch shape.
If the radius is needed in X + direction, the value must be greater than zero but less than that of available Width1.
If the radius is needed in Y + direction, the value must be greater than zero but less than that of available Length1.
If this value is set to zero, the software will create a sharp corner edge.