These properties define the geometry of the Nut.
For these properties, the default unit of distance is "mm". Specify "in" at the end of the dimensional value to use inches (for example 10in).
IJUAhsRodDiameter::RodDiameter
Specifies the outside diameter of the rod that attaches to the nut. This value is only used by the Part Selection Rule for choosing the correct Nut part. The rod is not included in the graphics.
IJUAhsShape1::Shape1Type
Specifies the graphic shape used for the nut or washer. This value uses the codelist number defined in the hsShapeType sheet in the HS_S3DParts_Codelist.xls workbook.
IJUAhsShape1::Shape1Width1
Specifies the outside dimension of the nut or washer.
IJUAhsShape1::Shape1Width2
Specifies the other outside dimension of the nut or washer.
IJUAhsShape1::Shape1Length
Specifies the length of the nut or washer.