Shape Properties - Intergraph Smart 3D - Reference Data - Hexagon PPM

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
Hangers and Supports
Search by Category
Reference Data
Smart 3D Version
13.1

These properties specify the shape of Strut_B. In general, the shape properties are defined as:

Shape1Width1 is in X direction
Shape1Width2 is in Y direction (into the page)
Shape1Length is in Z direction (along length of strut/snubber)

IJUAhsShape1::Shape1Type

Specifies the graphic shape. The center hole shown in figure is only for the reference and will not be modeled. The value for this column is a codelist number from the HS_S3DParts_Codelist.xls workbook on the hsShapeType sheet.

1 - Round

2 - Square

3 - Hex

IJUAhsShape1::Shape1Width1

Specifies the outside dimension of the shape.

1 - Round

2 - Square

3 - Hex

IJUAhsShape1::Shape1Width2

Specifies the outside length of the shape. If this value is set to zero or a negative value, then Shape1Width1 is used. This value is not used for the hex shape.

1 - Round

2 - Square

IJUAhsShape1::Shape1Length

Specifies the length of the shape.