The Leg 1 Offset attributes specify the offset for the steel leg connection to the top plate. A Hold Down support uses the following Leg 1 Offset attributes:
Name |
User Name |
Category |
On Property Page |
Read Only |
---|---|---|---|---|
Leg1Offset1 |
Leg 1 - Offset 1 |
Dimensions |
Yes |
No |
Leg1Offset1Rule |
Leg 1 - Offset 1 Rule |
Dimensions |
No |
Yes |
Leg1Offset1Definition |
Leg 1 Offset 1 Definition |
Dimensions |
No |
Yes |
Leg1Offset1Selection |
Leg 1 - Offset 1 Selection |
Dimensions |
No |
Yes |
Leg1Offset2 |
Leg 1 - Offset 2 |
Dimensions |
Yes |
No |
Leg1Offset2Rule |
Leg 1 - Offset 2 Rule |
Dimensions |
No |
Yes |
Leg1Offset2Definition |
Leg 1 Offset 2 Definition |
Dimensions |
No |
Yes |
Leg1Offset2Selection |
Leg 1 - Offset 2 Selection |
Dimensions |
No |
Yes |
Attribute Name |
Description |
Implementation Details |
---|---|---|
IJUAhsLeg1Offset1:: |
Specifies the offset for the Leg 1 connection to the plate along the main steel member. |
The following definitions are supported: 1 - Center to Center 2 - Edge to Edge |
IJUAhsLeg1Offset2:: |
Specifies the offset for the Leg 1 connection to the plate perpendicular to the main steel member. |
The following definitions are supported: 1 - Center to Center 2 - Edge to Edge |
Leg 2 Offset Attributes
The Leg 2 Offset attributes display the same behavior as the Leg 1 Offset attributes.