The following attributes are used to configure the support:
Attribute Name |
Description |
Implementation Details |
---|---|---|
IJUAhsStanchionOffset:: |
Specifies the offset from the supporting structure. |
|
IJUAhsStanchionOffsetRl::OffsetFromStructureRl |
Specifies a rule to get the ‘OffsetFromStructure’ value. |
If you specify a value, the software gets the ‘OffsetFromStructure’ using rule. |
IJUAhsGroutThickness:: |
Specifies the thickness of the grout. |
If GroutThickness is set to zero or is blank, the software uses the thickness from the grout part. |
IJUAhsGroutAngl:: |
Specifies the angle between the top and bottom edges of grout. |
Any value less than 90 degrees is supported. |
IJUAhsAnchorBoltX:: |
Specifies the offset for anchor bolt X. |
Use the following definitions: 1 - Offset from the base plate 2 - Offset between bolts 3 - Offset from the centerline of the base plate |
IJUAhsAnchorBoltY:: |
Specifies the offset for anchor bolt Y. |
Use the following definitions: 1 - Offset from the base plate 2 - Offset between bolts 3 - Offset from the centerline of the base plate |
IJUAhsAnchorBoltZ:: |
Specifies the offset for anchor bolt Z. If a base plate is not included, the software uses the top of the grout for the measurement. |
Use the following definitions: 1 - Distance above plate 2 - Distance from the center of plate to the center of the bolt |
Stiffener Attributes
Attribute Name |
Description |
Implementation Details |
---|---|---|
IJUAhsStiffenerSup::StiffenerSupport |
Specifies the part number or the part class of a stiffener part. The part must be a plate SmartPart. |
|
IJUAhsStiffenerSupRl::StiffenerSupportRule |
Specifies a rule that returns the part number of the stiffener part. |