Gusset Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

PPMProductFamily
3D Design and Visualization
PPMProduct
Intergraph Smart 3D
PPMCategory
Reference Data
Version_S3D
12.x(2018)

The following properties define the basic geometry of the optional gusset.

IJUAhsWidth5::Width5

Specifies the primary width of the gusset. This value must be greater than zero, or no gussets are modeled.

IJUAhsLength5::Length5

Specifies the primary length of the gusset. This value must be greater than zero, or no gussets are modeled.

IJUAhsThickness5::Thickness5

Specifies the primary thickness of the gusset. This value must be greater than zero, or no gussets are modeled.

IJUAhsWidth6::Width6

Specifies the secondary width of the gusset. This value must be greater than or equal to zero.

IJUAhsLength6::Length6

Specifies the secondary width of the gusset. This value must be greater than or equal to zero.

IJUAhsOffset3::Offset3

Specifies the horizontal position of the gusset's corner.

IJUAhsOffset4::Offset4

Specifies the vertical position of the gusset's corner.

IJUAhsMulti1::Multi1Qty

Specifies the quantity of gussets on each side. Gussets are not shown when Multi1Qty is set to zero.

IJUAhsMulti1::Multi1LocateBy

Specifies the location of the bolts. Each bolt can be located in two ways.

1 - Relative to center of the group
2 - Relative to edge.

The exact meaning depends on the quantity of bolts. This value can be 0 (nothing), 1 (center), or 2 (Edge).

IJUAhsMulti1::Multi1Location

Specifies the distance for the exact location of the gussets depending on Multi1LocateBy and Multi1Qty. This value can be either a distance to the end or a center-to-center spacing between the gussets.