IJUAhsLength2::Length2
Specifies the length of the top plate. Length2 is an optional property and if you do not assign a value, the software does not display the top plate.
IJUAhsWidth2::Width2
Specifies the width of the top plate. Width2 is an optional property and if you do not assign a value, the software does not display the top plate.
IJUAhsThickness2::Thickness2
Specifies the thickness of the top plate. Length2 is an optional property and if you do not assign a value, the software does not display the top plate.
IJUAhsTLCorner2::TLCornerType2
Specifies the corner type of the top plate. Use codelist value 1 for this corner type. See the hsCornerShape sheet from the HS_S3DParts_Codelist.xls workbook for all the valid codes. CornerType2 is applicable for all the vertical plates if the plate quantity is greater than 1.
IJUAhsTLCorner2::TLCornerX2
Specifies the horizontal size of the rectangular notch. TLCornerX2 takes a positive value and must be less than the Width1 value.
IJUAhsTLCorner2::TLCornerY2
Specifies the vertical size of the rectangular notch. TLCornerY2 takes a positive value and must be less than the Height1-Thickness1 value.
IJUAhsTLCorner2::TLCornerRadius2
Specifies the radius of the angled notch shape. Use the TLCornerRadius2 value when the two outside points of the notch must be rounded using the corner radius value.