These properties specify the side feature shapes properties for the Strut_A. Define values only when the side shape is needed.
IJUAhsLoc1:Loc1X
Enter the X coordinate distance for the start position of the center (not the edge) of the side nut shape.
IJUAhsLoc1:Loc1Y
Enter the Y coordinate distance for the start position of the center (not the edge) of the side nut shape.
IJUAhsLoc1:Loc1Z
Enter the Z coordinate distance for the start position of the center (not the edge) of the side nut shape.
The black dot in the figure represents the Loc1 position, which might have XYZ values of (-5.5", 0", 12") for example.
IJUAhsDirection1::Direction1
Specifies the orientation direction of the side nut shape relative to the LOC1 start position. In the example figure above, the shape runs in the positive Z direction from the start position. The values for this property are in the HS_S3DParts_Codelist.xls on the hsDirection sheet.
0 is positive X
1 is negative X
2 is positive Y
3 is negative Y
4 is positive Z
5 is negative Z