Extension Plate Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12 (2018)

IJUAhsTopPlate::TopPlateThickness

Specifies the thickness of the top plate.

IJUAhsTopPlate::TopPlateHeight

Specifies the height of the top plate. If the value is zero, the height is calculated from the symbol code based on the specified Gap and TopPlateOffset.

IJUAhsTopPlate::TopPlateLength

Specifies the length of the top plate.

IJUAhsTopPlate::TopPlateGap

Specifies the gap between the top of the shoe and the bottom of the pipe.

IJUAhsTopPlate::TopPlateOffset

Specifies the vertical downward offset of the extension plate from the top of the shoe.

IJUAhsTopPlate::Inside

Determines whether the extension plate is attached to the inside or outside the vertical plates. Enter codelist value 0 for inside or 1 for outside. The coldelist values are defined on the hsExtensionType sheet in the HS_S3DParts_Codelist.xls workbook.

IJUAhsTopPlate::Extension

Specifies if the extension plate is used or not. Extension plates are not supported for ShoeTypes 7, 8, 9 and 10.

IJUAhsExtPltOff::ExtensionPlateAxialOffset

Specifies a value to offset the extension plate along the x-axis of the pipe.