Block Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12 (2018)

These properties are optional and can be used to specify two stacked rectangular blocks that represent slide plates, shims, insulation pads, cradles, and so on. Enter the values for these properties only when block geometry is required.

The position of Block1 is exactly Gap1 below the bottom of the pipe. The position of Block2 is on top of Block1. Both blocks have similar input properties – height, width and length. These blocks will not be included if any of these properties are set to zero.

IJUAhsGap1::Gap1 (Optional)

Specifies the distance between the bottom of the pipe and the top of Block1.

This value can be negative, zero, or positive value. If it is set to zero no gap exists between the pipe and Block1. If it is set to a positive value there is a gap of the specified value between the pipe and the top of Block1. If it is set to negative value Block1 is partially embedded into the pipe.

IJUAhsHeight1::Height1 (Optional)

Specifies the height of the block.

IJUAhsWidth1::Width1 (Optional)

Specifies the width of the block.

IJUAhsLength1::Length1 (Optional)

Specifies the length of the block in the direction of the pipe.