Spacer/Roller Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12 (2018)

These properties define the geometry of the spacer/roller, which is an optional component when ClevisBotShp equals 1 or 2. Values for these properties are necessary only when spacer/roller geometry is required.

IJUAhsPin2::Pin2Diameter (Optional)

If ClevisBotShp is not equal to 3, this value specifies the diameter of the bolt. If ClevisBotShp is equal to 3, then this value specifies the small diameter of the roller. This value is always greater than Pin1Diameter; otherwise, the spacer is not included. If this value is less than or equal to Pin1Diameter, then the software sets 0.5 * Diameter1 as the default value.

  • ClevisBotShp = 1 or 2

  • ClevisBotShp = 3

IJUAhsPin2::Pin2Length (Optional)

Specifies the length of the spacer/roller. If this value is equal to zero, then the software sets Diameter1 as the default value. If ClevisBotShp = 1 or 2, this value is always less than the smaller of Diameter1 or Length1. If ClevisBotShp = 3, this value is always less than or equal to Length2.

  • ClevisBotShp = 1 or 2

  • ClevisBotShp = 3

IJUAhsDiameter2::Diameter2 (Optional)

If ClevisBotShp = 3, this value is the larger diameter of the roller. If this value is less than or equal to zero, then the software sets 2 * Pin2Diameter as the default value. If ClevisBotShp = 1 or 2, this property value is not used.