Flat Base Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12 (2018)

These properties are used to create flat base geometry of the saddle. If these properties are left as blank or zero, then the part creates the dimensions based on the rules provided in the symbol code.

IJUAhsWidth1::Width1

Specifies the distance from the vertical center line of the pipe to the left outside edge of the saddle. The software draws a flat base only if Width1 and Width2 are greater than zero. If Angle1 and Angle2 are specified then the software calculates the length of the base using the angles.

IJUAhsWidth2::Width2

Specifies the distance from vertical center line of the pipe to the right outside edge of the saddle. The software draws a flat base only if Width1 and Width2 are greater than zero. If Angle1 and Angle2 are specified, then the software calculates the length of the base using the angles.

IJUAhsWidth3::Width3

Specifies the distance from the vertical center line of the pipe to the left overhang of the saddle. Width3 is always greater than or equal to Width1.

IJUAhsWidth4::Width4

Specifies the distance from the vertical center line of the pipe to the right overhang of the saddle. Width4 is always greater than or equal to Width2.