End Nut Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12 (2018)

These properties specify the end nut shape properties for the turnbuckle.

IJUAhsShape1::Shape1Type

Enter the codelist number of the shape type as defined in the hsShapeType sheet in the HS_S3DParts_Codelist.xls workbook.

In each of the following examples, the end nut shape is depicted with hatched lines.

  • 1 - Round

  • 2 - Square

  • 3 - Hex

IJUAhsShape1::Shape1Width1

Specifies the outside dimension of the end nuts. If this value is set to zero, the end nut shape is not displayed.

  • 1 - Round

  • 2 - Square

  • 3 - Hex

IJUAhsShape1::Shape1Width2

Specifies the outside length of the end nut shapes. If this value is set to zero, then the value specified in Shape1Width1 is used. This value is not used for Hex Shape.

  • 1 - Round

  • 2 - Square

IJUAhsShape1::Shape1Length

Specifies the thickness of the end nut shape. Both positive and negative values are acceptable. If this value is set to a negative, then the end nut shapes are located within Opening1. If this value is set to zero, then the end nut shape is not displayed.

  • Shape1Length < 0 (Negative)

  • Shape1Length > 0 (Positive)