Dummy Leg shape Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

PPMProductFamily
3D Design and Visualization
PPMProduct
Intergraph Smart 3D
PPMCategory
Reference Data
Version_S3D
12.x(2018)

IJUAhsDummyShape::DummyShape

Specifies the dummy leg shape.

Allowed values for DummyShape are shown below. Allowed values are codelisted values from hsDummyStanc sheet of HS_S3Dcodelist.xls.

IJUAhsDummyHeight::DummyHeight

Specifies the total height of the dummy leg shape excluding base plate height. If DummyHeight is not specified, then the shape is of variable length.

IJUAhsDummyWidth::DummyWidth

Specifies the width of the dummy leg. DummyWidth must be a positive value. If the dummy leg shape is round, then DummyWidth is used as the diameter.

IJUAhsDummyDepth::DummyDepth

Specifies the depth of the dummy leg shape. If the dummy leg shape is round, then DummyDepth is not used.

IJUAhsDummyDia::Diameter

Specifies the diameter of the pipe connected to the dummy leg. If Diameter is not specified, it is overridden by Diameter1 from the Dummy Leg part class.