Curved End Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

PPMProductFamily
3D Design and Visualization
PPMProduct
Intergraph Smart 3D
PPMCategory
Reference Data
Version_S3D
12.x(2018)

These properties define a curved end at top edge.

IJUAhsCurvedEndType::CurvedEndType

Specifies the type of curve end, whether concave or convex and is applicable to TwoHolePort or RoutePort. This property uses the following codelist values:

1 - Concave

2 - Convex

IJUAhsCurvedEnd::CurvedEndRad

Specifies the radius of the curved end, concave shape in top edge. This value must be positive. The curved edge is not seen if this value is zero.

IJUAhsCurvedEnd::CurvedEndX

Specifies the horizontal offset of the curve center point. The default position is center of plate. Positive values offset the center point to the right. Negative values offset the center point to the left. The end points of the curve must remain on the top edge that remains after corner treatments are applied.

Positive X offset

IJUAhsCurvedEnd::CurvedEndY

Specifies the vertical offset of the curve center point. The default position is top edge of plate. Positive values offset the center point up, off the plate, as for a pipe centerline. Negative values offset the center point down, into the plate. The absolute value of CurvedEndY must be less than that of CurvedEndRad.

Positive Y offset

Negative Y offset