These properties specify the shape of Strut_B. In general, the shape properties are defined as:
Shape1Width1 is in X direction
Shape1Width2 is in Y direction (into the page)
Shape1Length is in Z direction (along length of strut/snubber)
IJUAhsShape1::Shape1Type
Specifies the graphic shape. The center hole shown in figure is only for the reference and will not be modeled. The value for this column is a codelist number from the HS_S3DParts_Codelist.xls workbook on the hsShapeType sheet.
1 - Round
2 - Square
3 - Hex
IJUAhsShape1::Shape1Width1
Specifies the outside dimension of the shape.
1 - Round
2 - Square
3 - Hex
IJUAhsShape1::Shape1Width2
Specifies the outside length of the shape. If this value is set to zero or a negative value, then Shape1Width1 is used. This value is not used for the hex shape.
1 - Round
2 - Square
IJUAhsShape1::Shape1Length
Specifies the length of the shape.