Bolt Properties (Stanchion Shape) - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
11 (2016)

IJUAhsIncludeBolts::IncludeBolts

Specifies whether bolts are included. Allowed values for IncludeBolts are

1- No bolts
2- Bolts for bottom plate only
3- Bolts for top plate only
4- Bolts for both top and bottom plates

Allowed values are codelisted values from the hsIncludeBolts sheet of the HS_S3Dcodelist.xls workbook.

IJUAhsPin1::Pin1Diameter

Specifies the pin diameter for all the bolts.

IJUAhsPin1::Pin1Length

Specifies the pin length for all the bolts.

IJUAOffset1::Offset1

Specifies the offset of each bolt row from the top shape.

IJUAhsMulti1::Multi1Qty

Specifies the quantity of bolts on one side of the plate. For example, when Multi1Qty is set to 2, the number of bolts on the plate are 4, 2 on each side of the plate. Bolts are not shown when Multi1Qty is set to zero.

IJUAhsMulti1::Multi1LocateBy

Specifies the location of the bolts. Each bolt can be located in two ways.

1 - Relative to center of the group
2 - Relative to edge.

The exact meaning depends on the quantity of bolts. This value can be 0 (nothing), 1 (center), or 2 (Edge).