IJUAhsRodDiameter::RodDiameter
Specifies the outside diameter of the rod that attaches to the swivel ring. The rod does not display as part of the swivel ring and does not affect the graphics. The rod diameter value is mandatory. If the value is set to zero, a warning displays.
IJUAhsRodTakeOut::RodTakeOut
Specifies the distance from the pipe centerline to the bottom of the rod. This value specifies the location of the rod end port. This value must be greater than Height1 + (2 X Thickness1).
IJOAhsPipeOD::PipeOD
Specifies the outside diameter of the pipe. This value must be greater than zero. It determines the inside diameter of the clamp unless Diameter1 greater than PipeOD.
The band curve does not necessarily stop at the pipe centerline. This curve wraps around the pipe until a tangent line can be drawn from the edge of the pipe to the lower face of the top on that side.