IJUAhsLength::Length
Specifies the length of the beam.
IJUAhsBBGap::BBGap
Specifies the gap for a back to back channel. The software draws the section only if the gap is zero. If the gap is more than the zero then, the software draws more than two sections in a back to back configuration with spacing that is equal to BBGap.
IJUAhsSteelSection::SteelName
Specifies the name of the steel section.
IJUAhsSteelSection::SteelType
Specifies the type of the steel section.
IJUAhsSteelSection::SteelStandard
Specifies the standard of the steel section.
IJUAhssteelAngle::SteelAngle
Specifies the angle of rotation along the x-axis for the steel section.
IJUAhsSteelCPoint::SteelCpoint
Specifies the cardinal point of the steel section.