These properties specify the thread connection properties for the block clamp.
IJUAhsShapeType::ShapeType
Specifies the type of shape to use for the top connection graphic. Enter a codelist number from the HS_S3DParts_Codelist.xls workbook on the hsShapeType sheet. Allowed codelist numbers for hsShapeType are:
-
1 - Round
-
2 - Square (Rectangle)
-
3 - Hex
IJUAhsThickness6::Thickness6
Specifies the thickness of the top (down) connection shape, which is defined as the outside face of the clamp to the outside face of the side connection.
IJUAhsWidth7::Width7
Specifies the outside dimension of the top (down) connection shape.
1 - Round
2 - Square
3 - Hex
IJUAhsWidth8::Width8
Specifies the width of the inside connection shape. For ShapeType2 (square), use Width8 to create a rectangle instead of a square. If this value is zero or not specified, ShapeType2 is a square shape.