IJUAhsRodDiameter::RodDiameter
Specifies the outside diameter of the rod that is attached to the clevis hanger.
IJUAhsSize::Size (Optional)
Used for part selection rules for choosing a correct clevis hanger part and is not used for creating graphics.
IJUAhsMinRod::MinRod (Optional)
Specifies the minimum amount of rod required by the clevis hanger. This value is not used for creating graphics.
IJOAhsAngle1::Angle1
Specifies the slope of the pipe on which the clevis hanger part is being used. By default, this value is set to zero. If it is not equal to zero, the clevis hanger will pivot about the bolt with the given angle as shown in Fig. 2.
IJUAhsClevisTopShp::ClevisTopShp
Specifies the top shape of the clevis hanger. The value for this column is a codelist number, and valid codes are listed in the HS_S3DParts_Codelist.xls workbook in the hsClevisTopShape sheet.
-
1 = Shape 1
-
2 = Shape 2
-
3 = Shape 3
IJUAhsClevisBotShp::ClevisBotShp
Specifies the bottom shape of the clevis hanger. The value for this column is a codelist number, and valid codes are listed in the HS_S3DParts_Codelist.xls workbook in the hsClevisBotShape sheet.
-
1 = Round
-
2 = Vee
-
3 = None - Used to create a hanger roller, as shown below:
IJUAhsRodTakeOut::RodTakeOut
Specifies the distance from the pipe centerline to the end of the rod that attaches to the clevis hanger. This value is always greater than 0.5 *Diameter1 + Pin1Diameter.
IJUAhsHeight1::Height1
Specifies the distance from the pipe centerline to the top of the clevis hanger. This value is always greater than RodTakeOut.
IJUAhsDiameter1::Diameter1
Specifies the total inside diameter of the clevis hanger. If ClevisBotshp = 3, set this value the same as the pipe diameter.