These properties define the geometry of a nut.
IJUAhsShape1::Shape1Type
Specifies the graphic shape that is used for the nut or washer.
Uses the codelist number defined in the hsShapeType sheet in the HS_S3DParts_Codelist.xls.
IJUAhsShape1::Shape1Width1
Specifies the Width of the oval shape representing the threaded base of the eye nut.
IJUAhsShape1::Shape1Width2
Specifies the other outside dimension of the nut or washer. You can use the Shape1Width2 to create a rectangle shape instead of a square.
If it is set to zero, negative, or not specified, Shape1Width1 is used as Shape1Width2.
IJUAhsShape1::Shape1Length
Specifies the Height of the oval shape representing the threaded base of the eye nut.