These properties specify the two vertical side plate properties of the welded beam attachment. Both side plates always need to be included.
IJUAhsGap1::Gap1
Enter the inside gap between the two side plates. This value can be zero but not a negative. If this value is set to zero, the sides are not drawn.
IJUAhsThickness1::Thickness1
Enter the thickness of the two side plates. Only positive values are acceptable. If this value is set to zero, the sides are not drawn.
IJUAhsHeight1::Height1
Enter the total height of the side plates, including the base plate. Only positive values are acceptable. This value is the total height of the WBA Hole, not including the height of the extra rod connection. If a base plate or top feature is included, the height is included in Height1 (not added to it). Also, if the bottom plate is specified so that it overlaps the side plates, the thickness is not added to Height1.
IJUAhsWidth1::Width1
Enter the width of the side plates. Only positive values are acceptable.
IJUAhsOffset2::Offset2
Enter the front-to-back offset of side plates from the hole center. If this value is set to zero, then the side, top, and bottom plates are centered. Only positive values are acceptable. The edge of the side plate is located at a specified distance from the hole centerline. This value is used when WBA Hole part is used for non-symmetrical beam attachments.