1 - Port2:RodEnd2
2 - Bolt Head
3 - Top Washer Plates
4 - Rod
5 - Bottom Washer Plates
6 - Nut
7 - Port1:RodEnd1
IJUAhsWPlateShape::Shape3Type
Specifies the attributes for the washer plate shape types. This property uses the following hsShapeType codelist values:
1 - Round
2 - Square
3 - Hex
IJUAhsWPlateShape::Shape3Width1
Specifies the outer dimension of the washer plate shape. This property uses the following codelist values:
1 - Round
2 - Square
3 - Hex
IJUAhsWPlateShape::Shape3Width2
Specifies the outer dimension of the washer plate shape. This property uses the following codelist values:
1 - Round
2 - Square
3 - Hex
IJUAhsThickness3::Thickness3
Specifies the thickness of the washer plate.
IJUAhsTWPlateCount::TWPlateCount
Specifies the number of washer plates above the plate or the existing steel.
IJUAhsBWPlateCount::BWPlateCount
Specifies the number of washer plates below the plate or the existing steel.
IJOAhsGap1::Gap1
Specifies the gap between the top and the bottom washer plates. The top washer plate is always attached to the bottom of the bolt head. The bottom washer plate is always attached to the top of the nut (if a nut exists).
If no washer plates exist, the gap is calculated as the offset value between the bolt head and the nut. You can set this value using CSD.