IJUAhsSmartShapeType::SmartShapeType
Specifies the classification of the shape. Enter a codelist number from the hsSmartShapeType sheet in the HS_S3DParts_Codelist.xls workbook.
IJUAhsShoeType::ShoeType
Specifies the type of shoe. Enter a codelist number from the hsShoeType sheet in the HS_S3DParts_Codelist.xls workbook.
IJUAhsShoeHeight::ShoeHeight
Specifies the total height of the shoe including the base.
IJUAhsShoeWidth::ShoeWidth
Specifies the width of the shoe. You must enter a positive value.
IJUAhsShoeLength::ShoeLength
Specifies the length of the shoe. You must enter a positive value.
IJUAhsShoeShape::ShoeAngle
Specifies the slope angle of the pipe. Extension plates are sloped using this angle.
IJUAhsShoeSpaceFrm::ShoeSpaceFrm
Specifies the codelist value for the leg spacing. The following codelist values are supported:
-
1 - Leg space is measured from the edge
-
2 - Leg space is measured from the center
IJUAhsVerticalLeg::LegLowerSpacing
Specifies the spacing of the legs at the bottom. This property is used with ShoeType 7. This value must be less than the ShoeSpacing value. For type 7, ShoeSpacing is the space of the legs at the top.
IJUAhsShoeTapLength::TaperedLength
Specifies the spacing upper side length of the leg.
IJUAhsShoeTapAng::TaperedAngle
Specifies the angle of taper of the vertical leg.
Use TaperedLength or TaperedAngle to get tapered vertical members.
IJUAhsTaperStartFrom::TaperStartFrom
Specifies the length from the point at which the leg member starts.
IJUAhsTaper:Ends:TaperEnds
Defines the length from the point at which the tapering of the leg member ends from the top of the leg.
IJUAhsContinous::Continous
Specifies whether the shoe shape is continuous. Enter a codelist number from the hsYesNo sheet in the HS_S3DParts_Codelist.xls workbook.
The Continuous option is not available for tapered shoe.