When you move sloped pipe run components, connected components can move out of the minimum slope tolerance. This often happens when you move a loop or change the slope tolerance on an existing pipe run. To adjust the components so that they are within the minimum slope tolerance, use the following procedure:
-
Select the turn feature (typically an elbow) to move. For example, you might need to move an elbow so that the attached pipe slope is within the slope tolerance.
-
Click Modify Slope to display the Modify Slope Dialog.
-
Select the pipe leg to change.
-
Select a slope from the list that puts the component within the minimum slope tolerances.
-
Click OK to change the slope of the component.
-
Repeat steps 1 through 5 for each component that needs to change.