Route a flexible pipe from a P&ID run - Intergraph Smart 3D - Help - Hexagon

Intergraph Smart 3D Piping

Language
English
Product
Intergraph Smart 3D
Subproduct
Piping
Search by Category
Help
Smart 3D Version
13.1
SmartPlant Foundation / SDx Version
10

Your plant must be registered with the Smart 3D environment to use this procedure.

  1. Click SmartPlant > Retrieve Command to retrieve the P&ID drawing that contains the run that you want to route. You can skip this step if the P&ID has already been retrieved.

  2. Click SmartPlant > View P&ID Command to view the P&ID drawing that contains the run that you want to route.

  3. Click Route Flex Pipe Command Route Flex Pipe on the vertical toolbar.

  4. In the Run pull-down list on the Route Flex Pipe ribbon, select <Select from P&ID>.

  5. Select the run to route from the P&ID drawing.

  6. The New Pipe Run Dialog displays with properties populated from the design basis. Click OK to accept the properties given. This step saves the correlated run information and closes the dialog.

  7. Select the starting location of the flexible pipe. If process data was not defined on the P&ID, then you must manually type a temperature and pressure. If you select an equipment nozzle that is correlated with P&ID design basis data, the software automatically determines which run should be connected.

  8. Select the ending location of the flexible pipe.