These properties define optional geometry of the rod.
IJUAhsOffset1::Offset1
Specifies the location of the RodCenterType feature shape along the rod.
-
If Offset1 is 0, then RodCenterType shape is centered along the rod length.
-
Otherwise, Offset1 is calculated from End1:
IJUAhsThickness1::Thickness1
Specifies the thickness of RodEnd1Type and RodEnd2Type.
IJUAhsLength1::Length1
Specifies the length of RodEnd1Type and RodEnd2Type. For a spade end, the length is calculated from the port to the base of the spade. For round and square ends, the length is the same as RodCenterType length.
IJUAhsDiameter1::Diameter1
Specifies the outside diameter of RodEnd1Type, RodEnd2Type, and RodCenterType.
IJUAhsOverLength1::OverLength1
Specifies the length of RodEnd1Type that extends past or ends before End1.
IJUAhsOverLength2::OverLength2
Specifies the length of RodEnd2Type that extends past or ends before End2.
-
If OverLength is 0, the rod end coincides with the port.
-
If OverLength is positive, the length of the rod increases beyond the port.
Example: Spade end rod
-
If OverLength is negative, the length of the rod decreases before the port.
Example: Anchor rod embedded in concrete.
Length (reported in the bill of material) is not affected by over length. RepOverLen1 includes the over length.