Top Shape Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12.1 (2019)

These properties define the geometry of the top shape of the clevis hanger.

IJUAhsWidth1::Width1

Specifies the width of the top portion of the clevis hanger. This value is always greater than RodDiameter. In cases where it is less than or equal to zero, the software sets Width2 to its default value.

IJUAhsThickness1::Thickness1

Specifies the thickness of the top portion of the clevis hanger. This value must always be greater than zero. In cases where it is less than or equal to zero, the software sets Thickness2 to its default value.

IJUAhsHeight3::Height3

Specifies the height from the lowest part of the top section of the clevis hanger to the flat spot on top.

  • If ClevisBotShp ¹ 3 and Height3 is less than RodTakeOut - (Height2 - PinDiameter / 2), then the software sets Height1 - (Height2 - 1.5 * Pin2Diameter) as the default value.

  • If ClevisBotShp = 3 and Height3 is less than Height1 + Height2, then the software sets Height1 + (2 * Height2) as the default value.

IJUAhsHeight4::Height4

Specifies the height from the lowest part of the top section of the clevis hanger to the corner where the top angles in.

  • If ClevisBotShp ¹ 3 and Height4 is either less than Height3 or less than RodTakeOut - (Height2 - PinDiameter / 2), then the software sets 3 * Pin1Diameter as the default value.

  • If ClevisBotShp = 3 and Height4 is either less than Height3 or less than Height1 + Height2, then the software sets Height3 - (3 * Pin1Diameter) as the default value.

  • If ClevisTopShp = 3, then Height4 is ignored.

IJUAhsLength1::Length1

Specifies the length of the top flat spot. If this value is less than RodDiameter, then the software sets 3 * RodDiameter as the default value.

IJUAhsLength2::Length2

Specifies the top inside length, depending on which set of conditions is true:

  • Condition A

    • If ClevisBotShp ¹ 3 and Length2 is less than Length1 and ClevisTopShp = 1, then the software sets Diameter1 + 2 * Thickness2 as the default value.

      OR

    • If Length2 ¹ Length1 and ClevisTopShp = 3, then the software sets Length1 as the default value.

  • Condition B:

    • If ClevisBotShp = 3 and Length2 is less than Length1 and ClevisTopShp = 1, then the software sets Diameter1 + 2 * Thickness2 as the default value.

      OR

    • If Length2 is not equal to Length1 and ClevisTopShp = 3, then the software sets Length1 as the default value.

IJUAhsLength3::Length3

Specifies the length of the lower flat spot. This value is used only when ClevisTopShp = 2. If this value is less than or equal to zero and ClevisTopShp = 2, then the software sets 0.125 * Length1 as the default value.