These properties define the geometry of the liner, which is an optional component. Values for these properties are necessary only when liner geometry is required.
IJUAhsThickness3::Thickness3 (Optional)
Specifies the thickness of the liner from the inside edge of the clevis hanger.
IJUAhsHeight8::Height8 (Optional)
Specifies the height from the pipe centerline to the top of the liner. This value is always less than Height5.
IJUAhsThickness4::Thickness4 (Optional)
Specifies the overall thickness if the liner is a wrap. If this value is less than or equal to Thickness3, then the software just draws a liner.
