IJUAhsAddPlate::AdditionalPlateShape
Specifies the shapes for additional plates. If this value is not set, additional plates are not drawn.
IJUAhsAddPlate::PlateNumber
Specifies the number of additional plates
IJUAhsAddPlate::CenterDiameter
Specifies the diameter from which the additional plates are drawn.
IJUAhsAddPlate::PlateRotAngle
Specifies angle by which the plates are rotated about the x-axis of the pipe.
IJUAhsAddPlate::PlateAngle
Defines the angle between the plates.
IJUAhsAddPlate::AddPlateOffset1
Specifies the offset of the plates along the x-axis of the pipe.