Value |
Extend Near Corner |
Offset Near Corner |
Offset Near Corner |
---|---|---|---|
None |
|||
The purpose is to maintain maximum contact between the bounded and bounding objects. |
|||
Face To Inside Corner |
|||
The purpose is to clear all material from the inside of the bounding edge. |
|||
Face To Edge |
|||
The purpose is to clear all material from the inside of the bounding edge and in the vicinity of the inside corner. |
|||
Face To Outside Corner |
|||
The purpose is to clear all material from the inside of the bounding edge and the bounding edge itself. If there is no overlap on the outside then it behaves as Face To Outside. |
|||
Face To Outside |
|||
The purpose is to clear all material from the inside of the bounding edge, the bounding edge itself, and in the vicinity of the outside corner. If there is no overlap on the outside, the cut progresses to the outside of the bounded member. If the outside area is set back from the near corner, the offset value (separate question) is maintained. |
|||
Inside To Edge |
|||
The purpose is to clear material in the vicinity of the inside corner. If the overlap at the bounding edge is insufficient for the default feature, it behaves as Inside To Outside. |
|||
Inside To Outside Corner |
|||
The purpose is to clear material from the bounding edge and in the vicinity of the inside corner. If there is no overlap on the outside then it behaves as Inside To Corner. |
|||
Inside To Outside |
|||
The purpose is to clear all material from the bounding edge and in the vicinity of both corners. If there is no overlap on the outside, the cut progresses to the outside of the bounded member. If the outside area is set back from the near corner, the offset value (separate question) is maintained. |
|||
Inside Corner To Outside |
|||
The purpose is to clear material from the bounding edge and in the vicinity of the outside corner. If there is no overlap on the top, the cut progresses to the bounded top. If the outside area is set back from the near corner, the offset value (separate question) is maintained. |
|||
Edge To Outside |
|||
The purpose is to clear material in the vicinity of the outside corner. If there is no overlap on the outside, the cut progresses to the outside of the bounded member. If the outside area is set back from the near corner, the offset value (separate question) is maintained. |