The following graphics represent only one possible shape to satisfy each Shape at Edge condition. The location of the start and end points are of primary significance.
Value |
Bounded Inner Surface Intersects Edge |
Bounded Inner Surface Intersects Face |
Bounded Inner Surface Intersects Corner |
No Bounded Flange |
---|---|---|---|---|
None |
||||
The purpose is to maintain maximum contact between the bounded and bounding objects. |
||||
Face To Corner |
||||
The purpose is to clear all material inside the bounding edge. When there is no bounded flange, it behaves like Face To Outside if the overlap at the bounding edge does not exceed a threshold value. |
||||
Face To Edge |
||||
The purpose is to clear all material inside the bounding edge and the inside portion of the bounding edge. If there is no overlap between the bounded web and the bounding edge, it should behave like Face To Corner. When there is no bounded flange, it behaves like Face To Outside if the overlap at the bounding edge does not exceed a threshold value. |
||||
Face To Flange |
||||
The purpose is to clear all material inside the bounding edge, while leaving the bounded flange connected. If there is no bounded flange, it should behave like Face To Outside. |
||||
Face To Outside |
||||
The purpose is to clear all material around the bounding edge. |
||||
Inside To Edge |
||||
The purpose is to leave the bounded flange connected, if it exists, and clear material in the immediate vicinity of the bounding inside corner. If the overlap between bounded web and bounding edge is insufficient for the minimum radius, it should behave like Inside To Flange. When there is no bounded flange, it behaves like Face To Outside if the overlap at the bounding edge does not exceed a threshold value. |
||||
Inside To Flange |
||||
The purpose is to leave the bounded flange, if it exists, connected and clear material in the vicinity of the bounding inside corner as far as the bounded flange. If there is no bounded flange, it should behave like Inside To Outside. |
||||
Inside To Outside |
||||
The purpose is to disconnect the bounded flange, if it exists, and clear material in the vicinity of the bounding inside corner. |
||||
Corner To Flange |
||||
The purpose is to leave the bounded flange connected, if it exists, and disconnect the bounded web from the bounding edge if there is any overlap. If the overlap is insufficient for the default feature, the answer is not applicable and no feature should be placed. If there is no flange, it should behave like Corner To Outside. |
||||
Corner To Outside |
||||
The purpose is to disconnect the bounded flange, if it exists, and disconnect the bounded web from the bounding edge if there is any overlap. |
||||
Edge To Flange |
||||
The purpose is to leave the bounded flange connected, if it exists, and clear material just inside the bounded flange, while leaving the bounded web attached to the bounding edge if there is any overlap. If the overlap is insufficient for the default feature, the answer is not applicable and no feature should be placed. If there is no flange, it should behave like Edge To Outside. |
||||
Edge To Outside |
||||
The purpose is to disconnect the bounded flange, if it exists, and leave the bounded web attached to the bounding edge if there is any overlap. If there is no overlap, the flange is set back starting at the corner, but no additional material is removed from the web (compare to Corner To Outside). |