Sanitary toolbar: Sanitary U-Bend Vertical
Command line: VUBEN
Places a 180 degree u-bend normal to the X-Y plane with the return ends also normal to the X-Y plane. This command is typically used with pipe that is on the X-Y plane.
last point
Starts the component at the last point of the previously-created component.
Center
Places the bend at the center point of the arc of the bend.
<Type> End
Places the other end of the bend at the start point. The end type is defined by the current specification.
Up
Places the branch in the positive Z direction.
Down
Places the branch in the negative Z direction.