Thrd/SW Fittings toolbar: Thrd/SW Ecc Swage
Command line: SWGE
Places an eccentric reducer swage in the X-Y plane.
last point
Starts the component at the last point of the previously-created component.
Large end
Places the non-reducing end at the start point.
Small end
Places the reducing end at the start point.
Large end type
Specifies the end type connection at the large end of the swage.
Small end type
Specifies the end type connection at the small end of the swage.
Up
Places the flat side of the reducer in the positive Z direction.
Down
Places the flat side of the reducer in the negative Z direction.
This command reverses the main and reduction sizes automatically after execution.