Specifies the default offset values and lapped status for a bracket by supports. This tab is only visible after bracket creation when Plane by Selected Supports is selected for Select Plane.
Offset Values
Load Point
Specifies the support load point of each point used to calculate the bracket system plane. Offsets are measured from the load points. Load points are defined in the profile cross-section symbols. If one of the supports is a plate system, then the load point value is 0. See Key Points for more information.
U Offset
Specifies the offset along the local U axis of the support profile. The value is 0 if the bracket is not on the flange of a profile support.
V Offset
Specifies the offset along the local V axis of the support profile. The value is 0 if the bracket is not on the flange of a profile support.
Override
Select to specify different values for Load Point, U Offset and V Offset.
Lapped Status
Displays the status of each bracket support. Lapped is selected if the support is lapped. This value is set during bracket creation and cannot be changed here.