The AirFilterHumidifier sheet in the HVAC.xls workbook defines the air filter humidifiers that you want to have available in the Catalog.
PartNumber
Type the part number for the air filter humidifier. An example is AirFilterHumidifier400x200x275.
Part numbers for air filter humidifiers must be unique throughout the entire Catalog.
SymbolDefinition
Type the symbol definition for the air filter humidifier.
FaceWidth
Type the face width for the damper for the air filter humidifier.
FaceDepth
Type the face depth for the damper for the air filter humidifier.
ComponentType
Type the component type for the air filter humidifier.
PartDescription
Type a description for the type of part. An example is Air Filter Humidifier400x200 x180mm.
Width
Type the width of the duct for the air filter humidifier.
Depth
Type the depth of the duct for the air filter humidifier.
Length
Type the length of the air filter humidifier.
Thickness
Type the thickness for the air filter humidifier.
FlangeWidth
Type the width for the flange.
For the remaining properties, (i) indicates an integer corresponding to a nozzle number assigned to the cross section.
This method avoids a lengthy listing for all possibilities, like Nozzle(1):CrossSection, Nozzle(2):CrossSection, and Nozzle(3):CrossSection for three possible nozzles. When you type the nozzle properties in the workbook,
substitute a number for i to assign the nozzle to the appropriate property.
Nozzle(i):CrossSection
Type the related CrossSection object for the port.
Nozzle(i):EndPrep
Type the coded end preparation for the particular nozzle. Examples of end preparations include Threaded, Screwed, Plain End, Welded, Bolted, Female, Male, and Ferule. In the reference data, a number represents each type of end preparation (for example, 1 for Threaded, 2 for Screwed and so on).
Nozzle(i):Thickness
Type the thickness of the nozzle port.
Nozzle(i):FlangeWidth
Type the air filter width for the nozzle.
Nozzle(i):FlowDirection
Type the flow direction for the nozzle.
Nozzle(i):PortDepth
Type the depth of the port for the nozzle.
Nozzle(i):CptOffset
Type the offset value for the component.